On uneven ground place squares of plywood under one foot to level the ladder base and then secure it with wire or rope tied to stakes.
How to attach roof safety harness.
Equipped with 3d rings it can hold up to 310 pounds.
Since you might in the event of a fall putting lateral forces on the screws holding the anchor plate i would say the manufacture would not recommend using it in the manner you described.
All the workers must be trained and taught how to use the roofing safety gear and how to protect themselves from hazards.
This video includes securing the anchor point properly using the lanyard and how to wear the harnes.
Most roof safety harness inspectors will attach a small tag which has the next inspection date recorded.
Demonstration of how to safely utilize a safety harness.
That will keep it from sliding sideways as you step onto the roof.
Fasten the top of the ladder with rope or wire tied to a secure anchoring point such as a 20d nail driven into a rafter.
Body wear harness connectors lanyard roofing ropes buckles rope grabs hooks etc workers must be provided with roof safety equipment and gear in order to do their job in a safe manner.
The thunder model is rugged heavy duty and made to last.
All height safety webbing based ppe such as harnesses lanyards and rope lines must be inspected and certified every 6 months.
Occupational safety and health administration 12 anchors to sheathing single trusses or most.
The final rope you will be attaching is the lanyard.
Step 6 attach yourself.
It comes as a set that includes a rope roof anchor harness and lanyard for adjusting the tension of the rope.
Step 5 attach the final rope.
Notify your supervisor and have the harness inspected.
The straps are fluorescent yellow which allows you to be seen in low lighting they can be easily adjusted to fit you snug and comfortable.
Make sure you are wearing a safety harness and correctly attach yourself to the above system.
A harness and a lifeline or lanyard.
This runs from the rope grab onto the roof harness.
Roofing safety all employers in the construction industry must have a safety program.
The synthetic material is water.
Anchor points are usually installed on the roof and are used to connect lanyards lifelines and other forms of tie off which prevent a worker from falling.
Both permanent and temporary roof anchor points are available.
Roof anchors can be as simple as a d ring connection or as complex as a complete lifeline system.
If you re looking for a reasonably priced safety harness the kwiksafety thunder is a great choice.
If the equipment is out of date do not use it.
On a roof you usually install the center of the anchor over a roof truss or rafter and the other screws are into the roof sheathing.
