How Tight To Nail Vinyl Siding

Between nail head and vinyl.

How tight to nail vinyl siding.

Secure interlocking panel design provides a tight fit with no insulation gaps. Learn more on proper nailing for vinyl siding installation how to install vinyl siding. Tight nailing screwing or stapling will cause the vinyl siding to buckle with changes in temperature fig. Following is a discussion of how to do both.

Fully rolled over nail hem securely anchors panels to the wall. Do not nail to the extreme right or left of nail slot in siding panel. Prodigy one piece insulated siding system. Allow approximately 1 16 in.

Do not drive nails tight. Vinyl siding tends to expand and contract considerably with temperature changes. Center nails in slots. Next measure and cut the siding to fit the measurements of your soffit and push each panel into the j channel.

Drive nails straight and level. To install vinyl siding to the soffit and fascia area on your home nail lengths of j channel along the inner edge of the fascia leaving the nail heads out about 1 32 to 1 16 of an inch. This will permit expansion and contraction as well as prevent dimpling which causes waves in siding. For this reason manufacturers design it to hang loosely on the nails rather than to be tightly nailed like wood siding.

Allow approximately 1 32 0 8mm clearance the thickness of a dime between the fastener head and the vinyl. Also learn the right way to hang siding with insulation in mind. An expert guide on the best way to nail vinyl siding either by hand or using a power nailer. Simply go outside grab the lower edges of a siding course and try to slide it back and forth photo 1.

Vinyl siding that s nailed on too tight doesn t leave room for the materials to expand and contract and that causes ripples to form come summertime. Do not drive the head of the fastener tightly against the siding nail hem. Vinyl siding can either be nailed by hand with a hammer or by a power nailer.